Hey,
I'd be very grateful if any of you guys could help me out.
I've just built myself a new system (all new parts)
When I go to install XP Pro it gets to the point where it copies the files and reboots. After this it is supposed to reach the GUI with the XP logo.
However for me, it just starts the entire process again and says that an operating system already exists. I have over written the supposed already installed operating system and it just starts over.
I'm only running one Maxtor SATA.
I put in my old IDE hard drive and it got to the point where I could select whether to start XP normally or in safe mode (for some reason) I couldn't use the keyboard and when the time ran out it flashed a blue screen and restarted over.. that process is repeated too.
Thank you very much for any help.
I'd be very grateful if any of you guys could help me out.
I've just built myself a new system (all new parts)
When I go to install XP Pro it gets to the point where it copies the files and reboots. After this it is supposed to reach the GUI with the XP logo.
However for me, it just starts the entire process again and says that an operating system already exists. I have over written the supposed already installed operating system and it just starts over.
I'm only running one Maxtor SATA.
I put in my old IDE hard drive and it got to the point where I could select whether to start XP normally or in safe mode (for some reason) I couldn't use the keyboard and when the time ran out it flashed a blue screen and restarted over.. that process is repeated too.
Thank you very much for any help.