geek_gal
Daemon Poster
- Messages
- 1,245
Hey all,
Wanting some help...yet again...
Ive had trouble getting more hands on with my computer, all ive done really is clean out and dust out from my computer,
I havent had any confidence to actually remove or install anything, im too scared ill do something or blow up the comp or shocking myself, yes im bit of a wuss
I have tryed to remove my current hard drive and wanting to switch over hard drives for a while now but i cant,
Also ive googled for help and its not helping!
What i want to do it take out the hard drive im using now and put in my old hard drive not really wanting to transfer files or that, thats not much of a bother yet, and i dont need to install any OS's or anything yet its more to get into the swing of things and then i might be able to start on my new comp build and do it myself not sure yet...
So can you help me please!
I dont need to install anything like drivers or that do i?
Just unscrew the H/D and the cords and switch over to other H/D yes?
Should be simple
I dont 'really' understand about the jumpers/cords? Slave and master..
I think that if i was to use two H/Ds then you would need to set it up and slave(as to the master) im guessing but would i have to worry about that if im only using one H/D?
Thanks!
G.G
< Edit >
P.S..Hope it worked had trouble posting this thread
Also Thanks in Advance!
Wanting some help...yet again...
Ive had trouble getting more hands on with my computer, all ive done really is clean out and dust out from my computer,
I havent had any confidence to actually remove or install anything, im too scared ill do something or blow up the comp or shocking myself, yes im bit of a wuss
I have tryed to remove my current hard drive and wanting to switch over hard drives for a while now but i cant,
Also ive googled for help and its not helping!
What i want to do it take out the hard drive im using now and put in my old hard drive not really wanting to transfer files or that, thats not much of a bother yet, and i dont need to install any OS's or anything yet its more to get into the swing of things and then i might be able to start on my new comp build and do it myself not sure yet...
So can you help me please!
I dont need to install anything like drivers or that do i?
Just unscrew the H/D and the cords and switch over to other H/D yes?
Should be simple
I dont 'really' understand about the jumpers/cords? Slave and master..
I think that if i was to use two H/Ds then you would need to set it up and slave(as to the master) im guessing but would i have to worry about that if im only using one H/D?
Thanks!
G.G
< Edit >
P.S..Hope it worked had trouble posting this thread
Also Thanks in Advance!