Need help in wiring case to mortherboard

nj18

Beta member
Messages
2
Need help in wiring case to motherboard

Ok I'm building a PC and I need to connect the cords from the front panel like the USB and audio jacks. I have a BIOSTAR A770 A2+ motherboard http://www.newegg.com/Product/Product.aspx...82E16813138106R

These are the connections I need to plug in, I'll write what it says on the connector first then the color. If you could tell me where to plug them in on the mobo that would be great! Yes, I read the manual and I still don't know where to put it.

First cord (I think it's the sound stuff from the front):
Ground Black
ReturnR Gray
ReturnL Blue
Spkout L White
Spkout R Green
Mic-Bias Yellow
Mic-IN Pink


Next cord:
GND2 Black
DATA-2 White
DATA+2 Green
VCC2 Red


Another cord:
GND1 Black
DATA-1 White
DATA+1 Green
VCC1 Red


Last cord:
GND Black
VCC White
TPB Red
TPB+ Green
GND Black
TPA+ Blue
TPA- Orange



Thanks!
 

sniperviper21

Golden Master
Messages
5,452
Location
USA
look for matching letters next to plugs on the board itself, if the plug says "gnd" and then theres a gnd marked on the board, thats were it goes, most boards are easy to see, and its usually at the bottom of the board.
 

PokerDegenerate

Daemon Poster
Messages
1,465
what case do you have so we can see what you actually have for hookups in the front of the case. (USB, Power, Reset, Audio)
 

nj18

Beta member
Messages
2
This case http://www.newegg.com/Product/Product.aspx?item=N82E16811162037


I did figure out the audio and USB now I just need help with what I think is the Firewire.

GND Black
VCC White
TPB Red
TPB+ Green
GND Black
TPA+ Blue
TPA- Orange


Go to page 15 in the manual and you will see how the pins are listed on the mobo. I'm not sure about all of them.

EDIT: I think it is for the front panel header not a firewire cord.
 
Top