Jawbreaker4Fs
Beta member
- Messages
- 4
I am using a Soyo CK8 Dragon Plus Motherboard with a Soyo CX-5959 tower. My problem is that I'm not exactly sure how to connect the USB front panel of the case to the motherboard. The motherboard documentation has a picture of the USB20_1 connector on the motherboard:
http://img.photobucket.com/albums/v306/jawbreaker4fs/USB20_1_2.jpg
and the actual cables coming from the front of the case look like this (the one that's got too much light says USB 2+):
http://img.photobucket.com/albums/v306/jawbreaker4fs/USB20_1.jpg
There are two sets of these cables which are identical, except one says USB1 and the other USB2. My question is which of these goes where on the motherboard connector? Specifically... what is the VCC connector for? I would make an educated guess to say that it's power, but I'm not 100% sure. In addition, does each set of connectors connect to one side of the connector (in the diagram... do I put all the cables for USB1 on the left, and USB2 on the right?)? And my final question is that the one side of the connector has an extra spot for a grounding cable... is it ok to leave this empty, as I only seem to have one grounding connector per USB port?
Thank you all very much in advance for your help.
http://img.photobucket.com/albums/v306/jawbreaker4fs/USB20_1_2.jpg
and the actual cables coming from the front of the case look like this (the one that's got too much light says USB 2+):
http://img.photobucket.com/albums/v306/jawbreaker4fs/USB20_1.jpg
There are two sets of these cables which are identical, except one says USB1 and the other USB2. My question is which of these goes where on the motherboard connector? Specifically... what is the VCC connector for? I would make an educated guess to say that it's power, but I'm not 100% sure. In addition, does each set of connectors connect to one side of the connector (in the diagram... do I put all the cables for USB1 on the left, and USB2 on the right?)? And my final question is that the one side of the connector has an extra spot for a grounding cable... is it ok to leave this empty, as I only seem to have one grounding connector per USB port?
Thank you all very much in advance for your help.