Alexinator
In Runtime
- Messages
- 347
Here's the schematics for my plans on my new water cooling system arriving in about a week. I was going to go with having the rad on the outside, but decided that inside would be best for appearance. Plus it being outside could be dangerous.
All the tubing is half inch so i may need to reverse the rad/resivior so that the hoses don't kink.
Also, the fan above the CPU is connected to a heat sync that cools the NB and SB on my Striker Extreme, and I'd prefer it remained there. Also, the fan in the upper left hand corner is actually on the inside, couldn't do that in the diagram because of the PSU/HDD Cage block.
Ultimately the GPU (8800GTX) will also be WCed by the same loop. Well, comments or changes that you'd make?
All the tubing is half inch so i may need to reverse the rad/resivior so that the hoses don't kink.
Also, the fan above the CPU is connected to a heat sync that cools the NB and SB on my Striker Extreme, and I'd prefer it remained there. Also, the fan in the upper left hand corner is actually on the inside, couldn't do that in the diagram because of the PSU/HDD Cage block.
Ultimately the GPU (8800GTX) will also be WCed by the same loop. Well, comments or changes that you'd make?