pro2a
In Runtime
- Messages
- 382
- Location
- Pennsylvania
I installed my new motherboard last night and everything went perfect. One gripe I had about my new board is for whatever reason ASUS put the power, reset and LED switch connectors on the bottom left of the board instead of the bottom right. I literally had to pull the power switch cord through where the hard drives sit just to get the cables to reach. I even had to move my hard drives down 2 slots to make room for the cord. Even then the cord just barely made it. The LED connectors are almost tugging on the pin sitting on the motherboard. I stuck small piece of cardboard between the connectors just so it wasn't tugging on the pin. That is a temporary fix, but still the cord is very tight. I know this is not good.
I know they make extension cords, but it looks as if I have to buy each one separately. Is there anything out there that is a combo of all 3? That would be ideal. I looked around and all I could find were single cords for each connection. There is 1 power, 1 reset and 3 LED's (1 – 2 pin & 2 – 1 pin with a +/-).
Thanks for the help.
I know they make extension cords, but it looks as if I have to buy each one separately. Is there anything out there that is a combo of all 3? That would be ideal. I looked around and all I could find were single cords for each connection. There is 1 power, 1 reset and 3 LED's (1 – 2 pin & 2 – 1 pin with a +/-).
Thanks for the help.