R Rawmaterial In Runtime Messages 252 Dec 7, 2005 #1 I am trying to add a fan on my Arcylic case, what size fan should i add. i wanna add it on the top. and what can i use to cut the arcylic?
I am trying to add a fan on my Arcylic case, what size fan should i add. i wanna add it on the top. and what can i use to cut the arcylic?
A AND_YOU_ARE Fully Optimized Messages 2,003 Location Potsdam NY, USA Dec 7, 2005 #2 I used tin snips when cutting a fan hole on my aluminum case. But a dremal is a good tool, if you know some one with one, it makes modding easy. Tin snips wont work for you. For yours a drill or a saw.
I used tin snips when cutting a fan hole on my aluminum case. But a dremal is a good tool, if you know some one with one, it makes modding easy. Tin snips wont work for you. For yours a drill or a saw.
OP OP R Rawmaterial In Runtime Messages 252 Dec 7, 2005 #5 PoisonPorkchop said: I suggest a heated butter knife :| Click to expand... haha u serious? i was going to use very small drill bit, looking for someone on here that has acutally done it.
PoisonPorkchop said: I suggest a heated butter knife :| Click to expand... haha u serious? i was going to use very small drill bit, looking for someone on here that has acutally done it.
fr34ky !!GAMER!! Messages 509 Location Southeast,AZ Dec 8, 2005 #6 no dont use a jig saw but, tin snips cuase you'll have less of a chane to mess up.I used a dremel on my old comp.Iinstalled 6x120mm fans.Also be careful where you cut, that it wont take any rigidness of the case.
no dont use a jig saw but, tin snips cuase you'll have less of a chane to mess up.I used a dremel on my old comp.Iinstalled 6x120mm fans.Also be careful where you cut, that it wont take any rigidness of the case.