I recently purchased the below motherboard so that i could rebuild an older system to give it away. I was wondering if anyone could tell me what is the maximum power supply that I could use with this motherboard. Right now i am looking at either a 300w atx or a 400w atx. but would like suggestions and advice. i am looking for a new case and power supply combination.
FIC ASPEN2 Slot A Motherboard is a perfect companion to any Slot A Athlon processor.
Specification
Chipset
AMD 751 North Bridge
VIA VT82C686A Super South Bridge
Processor
Slot A Supports Athlon 500-1000MHz (1GHz) with 200MHz FSB
Memory
two 168-pin DIMM sockets for up to 512MB SDRAM, PC100 DIMM support
PC100 DIMM support
Provides ECC (Error Checking Correction) capability
BIOS
2Mb Flash RAM
ACPI
APM 1.2 / PnP 1.0a / SMBIOS 2.1 / DMI 2.0 / WfM 1.1a
Expansion Slots
five PCI, one AGP 1x/2x
Onboard I/O
1 RS-232 Serial Port (16550 UART compatible)
1 Parallel Printer Port (SPP/EPP/ECP mode)
1 FDD port (supports LS120, 3 mode, 1.2/1.44/2.88 MB FDD)
1 IEEE-1394 standard FireWire port
Provides IrDA port with optional cable for transceiver
PS/2 Mini-DIN mouse & keyboard ports
2 USB ports
Power Button and HD LED connectors
Hard Drive Interface
Supports two independent channels for 4 IDE devices
Support up to PIO mode 4 & UDMA 33/66 2 PCI bus mastering ATA E-IDE ports
Video
Not Included
Sound
Not Included
Form Factor
ATX, Four Layer PCB, 9.6" x 12"
thank you for your help!!!!!!!!!!!!!!!
FIC ASPEN2 Slot A Motherboard is a perfect companion to any Slot A Athlon processor.
Specification
Chipset
AMD 751 North Bridge
VIA VT82C686A Super South Bridge
Processor
Slot A Supports Athlon 500-1000MHz (1GHz) with 200MHz FSB
Memory
two 168-pin DIMM sockets for up to 512MB SDRAM, PC100 DIMM support
PC100 DIMM support
Provides ECC (Error Checking Correction) capability
BIOS
2Mb Flash RAM
ACPI
APM 1.2 / PnP 1.0a / SMBIOS 2.1 / DMI 2.0 / WfM 1.1a
Expansion Slots
five PCI, one AGP 1x/2x
Onboard I/O
1 RS-232 Serial Port (16550 UART compatible)
1 Parallel Printer Port (SPP/EPP/ECP mode)
1 FDD port (supports LS120, 3 mode, 1.2/1.44/2.88 MB FDD)
1 IEEE-1394 standard FireWire port
Provides IrDA port with optional cable for transceiver
PS/2 Mini-DIN mouse & keyboard ports
2 USB ports
Power Button and HD LED connectors
Hard Drive Interface
Supports two independent channels for 4 IDE devices
Support up to PIO mode 4 & UDMA 33/66 2 PCI bus mastering ATA E-IDE ports
Video
Not Included
Sound
Not Included
Form Factor
ATX, Four Layer PCB, 9.6" x 12"
thank you for your help!!!!!!!!!!!!!!!