scroudt
In Runtime
- Messages
- 174
- Location
- Houston, BC, Canada
Hey all, just finished installing windows on my new SSD. I forgot to set my bios to AHCI before installing, and continued to install drivers and a couple programs and such. I then remember to change the BIOS and when I did so, I saved and restarted, only to have windows not start up. A couple times it even tried to repair but failed. Did I miss something, or is this because I didn't set the BIOS to AHCI before installing windows?
this is what I've done so far:
Disable indexing
Disable defragmentation
Enabled Write Caching (to my data drive, second HDD)
Disable the Page File
Disable System Restore
I enabled Trim
I also just Disable Superfetch / Disable Prefetch, but have not tried restarting again since I did this.
Any suggestions?
this is what I've done so far:
Disable indexing
Disable defragmentation
Enabled Write Caching (to my data drive, second HDD)
Disable the Page File
Disable System Restore
I enabled Trim
I also just Disable Superfetch / Disable Prefetch, but have not tried restarting again since I did this.
Any suggestions?