Note: To install Windows, I have to use 'special' SCSI drivers from my motherboard manufacturer since the version of Windows that I have... Doesn't have them!!
When I was installing Windows, it asked me for the SCSI drivers. OK, I put them in, Windows continues the installation and then, almost at the end (partitioning and formating is over) it comes up with "Can not copy ---HERE'S THE SCSI DRIVER NAME---" and does that 3x for every file (SCSI driver) that needs to be copied.
I ignore this and continue with the installation. Finalizing. Windows restarts. Now I get a blue screen before booting to Windows
"A problem has been detected and windows has shut down to prevent damage to
your computer.
If this is the first time you've seen this stop error screen, restart your
computer. If this screen appears
again follow these steps:
Check for viruses on your computer. Remove any newly installed hard
drive or hard drive controllers.
Check your hard drive to make sure it is properly configured and
terminated.
Run CHKDSK /f to check for hard drive corruption, and then restart your
computer.
Technical Info:
*** Stop: 0x0000007B (0xF7C45640, 0x00000034, 0x00000000, 0x00000000)"
I searched for the above and came with quite few results. It happens when, EXACTLY, the SCSI drivers can not be found or they are corrupted or when the boot device is innaccesible (NO DRIVER!!!).
Is there a way to install the drivers manually? Where do I paste them, if so?
Thanks!
When I was installing Windows, it asked me for the SCSI drivers. OK, I put them in, Windows continues the installation and then, almost at the end (partitioning and formating is over) it comes up with "Can not copy ---HERE'S THE SCSI DRIVER NAME---" and does that 3x for every file (SCSI driver) that needs to be copied.
I ignore this and continue with the installation. Finalizing. Windows restarts. Now I get a blue screen before booting to Windows
"A problem has been detected and windows has shut down to prevent damage to
your computer.
If this is the first time you've seen this stop error screen, restart your
computer. If this screen appears
again follow these steps:
Check for viruses on your computer. Remove any newly installed hard
drive or hard drive controllers.
Check your hard drive to make sure it is properly configured and
terminated.
Run CHKDSK /f to check for hard drive corruption, and then restart your
computer.
Technical Info:
*** Stop: 0x0000007B (0xF7C45640, 0x00000034, 0x00000000, 0x00000000)"
I searched for the above and came with quite few results. It happens when, EXACTLY, the SCSI drivers can not be found or they are corrupted or when the boot device is innaccesible (NO DRIVER!!!).
Is there a way to install the drivers manually? Where do I paste them, if so?
Thanks!