stainer711
In Runtime
- Messages
- 429
Re: need help with problem with overclock e7200
Core temp reports a load temp of 53C at 1.35Vcore. (1.29vcore cpuz) I'm pretty sure i'm stable at this point. Now I could either back off to 1.34 and see how that goes or stay here. I may just stay at the 1.35 setting because Tom's Hardware is using the exact same FSB setting and has the same vdroop. However, Tom's vcore sounds arbitrary from reading the guide. It sounds like the 1.35vcore was the first they tried. I don't want to have a vcore that is higher than needed, but I don't think that 1.35 is really a problem.
I used large fft in P95. I am now running occt for two hours. I could probably run OCCT forever at 1.325vcore without a problem, but my IE errors would likely return. I haven't had any IE problems from 1.34vs up.
Core temp reports a load temp of 53C at 1.35Vcore. (1.29vcore cpuz) I'm pretty sure i'm stable at this point. Now I could either back off to 1.34 and see how that goes or stay here. I may just stay at the 1.35 setting because Tom's Hardware is using the exact same FSB setting and has the same vdroop. However, Tom's vcore sounds arbitrary from reading the guide. It sounds like the 1.35vcore was the first they tried. I don't want to have a vcore that is higher than needed, but I don't think that 1.35 is really a problem.
I used large fft in P95. I am now running occt for two hours. I could probably run OCCT forever at 1.325vcore without a problem, but my IE errors would likely return. I haven't had any IE problems from 1.34vs up.