ghostknight3
Baseband Member
- Messages
- 27
ok im not sure about this.. but the comp im looking at runs 350mhz. after some tweaking and such to make it run a little better i had the case apart and was looking at the jumpers.
after about 5 min of decideding what to do with them i changed form 1-2 to 2-3 config and restarted.
after this when i started up it went directly to setup and there was a new menu in which i could change the speed from 350mhz to 450. so why i figure why not and change. saved and exited. reset jumpers to 1-2 config and started it back up. after boot i look at speed again and its still at 350.
is this cause i put the jumpers back to 1-2?? but if i left them at 2-3 then it woulda went back to setup. is there a way to keep it at 450 or is this just showing what i can get it up to?
after about 5 min of decideding what to do with them i changed form 1-2 to 2-3 config and restarted.
after this when i started up it went directly to setup and there was a new menu in which i could change the speed from 350mhz to 450. so why i figure why not and change. saved and exited. reset jumpers to 1-2 config and started it back up. after boot i look at speed again and its still at 350.
is this cause i put the jumpers back to 1-2?? but if i left them at 2-3 then it woulda went back to setup. is there a way to keep it at 450 or is this just showing what i can get it up to?