CrazeD Fully Optimized Messages 3,736 Location Maine May 20, 2006 #1 My FSB is at 230MHz, and my HTT link was at 800MHz..is 1030 too much? I set it at 600MHz for now, is that right or should I leave it at 800?
My FSB is at 230MHz, and my HTT link was at 800MHz..is 1030 too much? I set it at 600MHz for now, is that right or should I leave it at 800?
T Trifid Fully Optimized Messages 4,010 May 20, 2006 #2 What socket is it? If it is 754 than you do not want to go above 800 to give you a 1600 with DDR. Socket 939 1030mhz is still too fast so would have to be the one below that.
What socket is it? If it is 754 than you do not want to go above 800 to give you a 1600 with DDR. Socket 939 1030mhz is still too fast so would have to be the one below that.
OP OP CrazeD Fully Optimized Messages 3,736 Location Maine May 20, 2006 #3 Socket 939..so 830 isn't too low?
Nitestick Golden Master Messages 8,478 Location Ñмерти Ð´Ð»Ñ Ñпаме May 20, 2006 #4 1030 would probably be acceptable but i doubt you would notice a difference between 830 and 1030.
OP OP CrazeD Fully Optimized Messages 3,736 Location Maine May 20, 2006 #5 Alright, I'll leave it at 830 then.