earwicker7
In Runtime
- Messages
- 345
I probably won't have time to redo the paste until this weekend, but I've got a feeling that should do it... I know I did a crappy job the first time, and I've never used the X method, so I probably did it wrong too. Should the grain of rice be horizontal or vertical?
The block is an EK Supreme HF CU, and I'm using the X-Adaptor which came with the board and allows you to use cooling blocks from 1366 boards. The mounting device uses thumb screws and springs... any rule of thumb on how tight they should go? What is the best method to make sure that the screws are tightened evenly, since there isn't an automatic stop point like on normal screws?
The voltage on in the BIOS was set at 1.24V... is that considered average?
The block is an EK Supreme HF CU, and I'm using the X-Adaptor which came with the board and allows you to use cooling blocks from 1366 boards. The mounting device uses thumb screws and springs... any rule of thumb on how tight they should go? What is the best method to make sure that the screws are tightened evenly, since there isn't an automatic stop point like on normal screws?
The voltage on in the BIOS was set at 1.24V... is that considered average?