Bitspower mod top s type

[kidmo87]

Hello. I have the bitspower mod top type s. My issue is that I am trying to put a 90 degree fitting on the outlet, and I got a g1/4 to g1/4 fitting to connect to my ball valve for the inlet. But they hit against each other and won't fit into the holes. The inlet and outlet holes are really close to each other. Does anyone have a suggestion on a fitting to connect to my ball valve that is thin enough to fit?
Thanks

 

[PP Mguire]

Give some links to the parts you're working with, specifically the fittings. Easier to visualize.

 

[kidmo87]

sorry about that.

Bitspower Mod Top:
www.amazon.com/Bitspower-Mod-Top-Model-White/dp/B00OBW2TC0

Bitspower 90 degree fitting:
Bitspower G1/4 Thread 90-Degree Rotary Adapter - White (BP-DW90R) - FrozenCPU.com

Bitspower G1/4 D-Plug Male / Male Coupler Set (I tried to use this for the ball valve)
Bitspower G1/4 D-Plug Male / Male Coupler Set - 31.55mm - White (BP-DWWP-C44) - FrozenCPU.com

 

[PP Mguire]

Yea that coupling is wider than a normal fitting. Not real sure how you'd get that on without some ghetto rigging that could give more risk of leaking.

 

[kidmo87]

I know the width has to be less than 18mm because I have 2 of those 90 degree fitting, and they both won't fit together

 

[PP Mguire]

It's 2mm smaller so maybe.

 

[kidmo87]

Yea, I just edited my post because I realized even with two 18mm wide fittings, they still touch

 

[PP Mguire]

Touching is fine if you can still get them tightened in there. I had a CPU block where my EK compression fittings would touch but I could still tighten them.

 

[kidmo87]

Yea, but those two won't fit either

 

[PP Mguire]

Then you're either going to have to change fittings or change that top. Maybe work with some adapters.