Jagged.Edge
Baseband Member
- Messages
- 73
Okay, I tried using the same settings again, as you posted, and disabled auto restart, so I managed to write down the bluescreen
I also restarted my computer several times, just to make sure it was the same error I was getting.
1) A problem has been detected and windows has been shut down to prevent damage to your computer ***STOP: 0x0000001E
There wasn't an error message for that one, and I bluscreened around 30 seconds after windows had loaded, and my desktop had popped up.
2)The system encountered an uncorrectable hardware error ***STOP: 0x00000124
This bluescreen happened while windows was at the log-in screen.
3)Same as 2
4)Same as 2, but I managed to log in for 2 seconds, then it bluescreened.
P.S, I've noticed, with the CPU Manual Voltage, 1.465 is colored red when I type it it and press enter, and if I press - to lower the voltage in 0.005 increments, around 1.300v it turns pink, 1.250 yellow, 1.2 white (I think), and then black under that. Does that matter?
I also restarted my computer several times, just to make sure it was the same error I was getting.
1) A problem has been detected and windows has been shut down to prevent damage to your computer ***STOP: 0x0000001E
There wasn't an error message for that one, and I bluscreened around 30 seconds after windows had loaded, and my desktop had popped up.
2)The system encountered an uncorrectable hardware error ***STOP: 0x00000124
This bluescreen happened while windows was at the log-in screen.
3)Same as 2
4)Same as 2, but I managed to log in for 2 seconds, then it bluescreened.
P.S, I've noticed, with the CPU Manual Voltage, 1.465 is colored red when I type it it and press enter, and if I press - to lower the voltage in 0.005 increments, around 1.300v it turns pink, 1.250 yellow, 1.2 white (I think), and then black under that. Does that matter?