kwangstarulz
Beta member
- Messages
- 3
I have a computer system based on a ASUS A7N8X-E Motherboard. I had 2 WD360D raptors running in a RAID 0 configuration until 1 was damaged and fails to power up I removed that one and now Im trying to use just 1 raptor drive for the computer. Whenever I start up the computer, I get an error message saying "incomplete raid set". After I get passed that and try to install using windows xp cd, I use the sata drivers for my controller and files are copied. After it reboots and the computer boots up again, it fails to continue the installation of windows xp. I believe it is because of the incomplete raid set.
My questions would be;
How would I solve this problem?
Do i use any jumper settings on the back of the drive if I am only using 1 drive? (previously I had 2 drives)
Ive deleted the partition on the drive and tried formatting but does not continue the installation of windows
My questions would be;
How would I solve this problem?
Do i use any jumper settings on the back of the drive if I am only using 1 drive? (previously I had 2 drives)
Ive deleted the partition on the drive and tried formatting but does not continue the installation of windows