RicoDirenzo
Fully Optimized
- Messages
- 2,107
I just purchased a WD Cav. 250 gig SATA. I presume, once installed as the master, any slave added must be in the same configuration (As SATA) and that the IDE 1 slot is. therefore, disabled. ???
Sata HD + IDE Slave?
- Thread starter RicoDirenzo
- Start date
- Status
RicoDirenzo
Fully Optimized
- Messages
- 2,107
Guess it is too dumb a question for a response...I'll do the research and finger it out myself!
Elbatrop1
Memberbot
- Messages
- 4,057
???
There is no Master and Slave for SATA.
Just to clarify, SATA is the one with the skinny cables.
PATA (IDE) is the one with the ribbon cables.
When you have a SATA HD and a IDE HD, you set the IDE HD to master, because it will be the only device on it's IDE channel.
Wait a little while before you give up on your post
Be patient, it will get answered.
There is no Master and Slave for SATA.
Just to clarify, SATA is the one with the skinny cables.
PATA (IDE) is the one with the ribbon cables.
When you have a SATA HD and a IDE HD, you set the IDE HD to master, because it will be the only device on it's IDE channel.
Wait a little while before you give up on your post
Be patient, it will get answered.- Status
