50mobber
In Runtime
- Messages
- 189
I oc'ed my Q6600 to 3.0Ghz. I wanted to get to 3.4Ghz if possible. Every time i try going over 3.0ghz i cant get it to be stable. I read every thread i could find on it and tried different tricks that i read about. But no luck. I also been looking at my temps and they seem to be high so im not sure if i could go any higher. When idle my temps are 44C to 35C.
Here are pics underload Prime95
Here is what i have in BIOS
Cpu Ratio Setting- 9
FSB-333
PCI-e-100
DRAM Frequency- Auto
DRAM timing Control-auto
DRAM Static Read- Auto
DRAM Read Timing- Auto
MEM. OC Charger- Auto
AI Clock Twister- Auto
AI Transaction Booster- Auto
CPU Volt-1.35625
CPU GIL Reference-Auto
CPU PLL Volt- Auto
FSB Termination- 1.2
DRAM Volt-2.1
NB Volt-1.2
SB Volt-auto
PCI-e auto
Load Line Calibration- Enabled
CPU Spread Spectrum- Disabled
PCI-e Spread Spectrum- Disabled
CPU Clock Spew- Auto
NB Clock Spew- Auto
CPU Margin Enhancement- Optimized
I haven't messed around with all the setting as i don't know what they do. Any help is greatly appreciated.
Here are pics underload Prime95
Here is what i have in BIOS
Cpu Ratio Setting- 9
FSB-333
PCI-e-100
DRAM Frequency- Auto
DRAM timing Control-auto
DRAM Static Read- Auto
DRAM Read Timing- Auto
MEM. OC Charger- Auto
AI Clock Twister- Auto
AI Transaction Booster- Auto
CPU Volt-1.35625
CPU GIL Reference-Auto
CPU PLL Volt- Auto
FSB Termination- 1.2
DRAM Volt-2.1
NB Volt-1.2
SB Volt-auto
PCI-e auto
Load Line Calibration- Enabled
CPU Spread Spectrum- Disabled
PCI-e Spread Spectrum- Disabled
CPU Clock Spew- Auto
NB Clock Spew- Auto
CPU Margin Enhancement- Optimized
I haven't messed around with all the setting as i don't know what they do. Any help is greatly appreciated.