jseber1982
Enterprise SCCM\SCOM
- Messages
- 904
- Location
- Atlanta, Ga
pc has been running decent for a while at 2.9. Now my 2.6ghz fx60 wont OC at all now. I changed the multplier from 13 to 13.5 to go up 100mhz and it wont even post. I slowly upped the voltage from its stock 1.36 all the way up to 1.5 and it still will not OC. I am sticking to a 200mhz fsb right now until i figure it out.
Just cant figure it out, iv seen other fx 60s and 57s on here and around town easily hit 3ghz with a watercooling system like mine. The temp on the the cpu never goes above 31*C.. approx 95*F. So the temps are good, but hmm, i dunno lol.
the mem is corsair xms 2.5-3-3-6, but that dont really matter because im not adjusting the fsb..
Same with the graphics cards lol,, the temps of them never go above 40*C full load. I can jack the mem and cpu voltages on them way up, and i cant seem to go higher than a 100mhz oc, sucks lol.
I guess im just not a skilled OCer lol.
Just cant figure it out, iv seen other fx 60s and 57s on here and around town easily hit 3ghz with a watercooling system like mine. The temp on the the cpu never goes above 31*C.. approx 95*F. So the temps are good, but hmm, i dunno lol.
the mem is corsair xms 2.5-3-3-6, but that dont really matter because im not adjusting the fsb..
Same with the graphics cards lol,, the temps of them never go above 40*C full load. I can jack the mem and cpu voltages on them way up, and i cant seem to go higher than a 100mhz oc, sucks lol.
I guess im just not a skilled OCer lol.