motherboard help

Status
Not open for further replies.

hokoboko18

Solid State Member
Messages
7
ok, so last night i replaced my power supply since mine was going out... after many complications, the only way i can boot up in windows is when my cmos on the mobo is set to clear... it seems to work just fine logging into windows, but i found it very strange... any ideas?
 

Alvin.C

Fully Optimized
Messages
2,581
Location
London
Re:

Hello,

So what happens then? Does it POST successfully (Power on and detect hardware etc..) but then fail to boot into the Operating System? Does a message appear?

Make sure that after you've cleared your CMOS, that your BIOS settings are configured correctly. Most importantly, ensure that you've defined the order boot order of your devices in the BIOS.
 
Status
Not open for further replies.
Top