MartinBaker
Beta member
- Messages
- 1
I have just built my computer and everything seems to work correctly. But I have two questions:
1) My SATA drive is the only hard disk, so is it necessary to load the via raid drivers.
2) Reading the instructions for fitting the drive it said to remove the jumper from the back, which I did. Should this have been left on the master setting or does it not matter that it has no jumper attached. The disk works fine and is recognised.
Thanks in advance for any help
1) My SATA drive is the only hard disk, so is it necessary to load the via raid drivers.
2) Reading the instructions for fitting the drive it said to remove the jumper from the back, which I did. Should this have been left on the master setting or does it not matter that it has no jumper attached. The disk works fine and is recognised.
Thanks in advance for any help