O overclocker Baseband Member Messages 83 Sep 29, 2004 #1 I jest got a new TI-83 plus, and the USB cable is not in stalling, because there is a driver missing. Any suggestions?
I jest got a new TI-83 plus, and the USB cable is not in stalling, because there is a driver missing. Any suggestions?
A ag3 Fully Optimized Messages 1,536 Sep 29, 2004 #2 Have you installed the appropriate drivers for your South Bridge? They should have been included with your motherboard.
Have you installed the appropriate drivers for your South Bridge? They should have been included with your motherboard.
B beedubaya Golden Master Messages 5,283 Location Oklahoma Sep 29, 2004 #4 I have that problem too sometimes. It all depends on what order you insert the usb cable and start the software in.
I have that problem too sometimes. It all depends on what order you insert the usb cable and start the software in.
O overclocker Baseband Member Messages 83 Sep 29, 2004 #5 so what order do you insert the usb cable and start the software in.
B beedubaya Golden Master Messages 5,283 Location Oklahoma Sep 29, 2004 #6 I don't remember, its been a loong time since I used that. Just do it by trial and error.