Hey, so i bought the CamJam Edukit 3 for my RPI, and it has illuminated a very simple issue i have: I suck at wiring. I've never done it before, and the instruction in building the robot which says "connect the wire to the controller screw terminals" just aint working for me. I can get the wire in a little, but it wont stay there (it falls out when i let go). I'm assuming this is a me problem, but it is a different motor controller board than in all the images and guides, so maybe they sent the wrong board?
Here's the image of the wire next to the port it's supposed to go into. Is it literally as simple as it should be pushing the wire in as hard as possible, or is there a trick to it that I need to be using?
In case it helps at all, this is the workbook guide that shows how to build it:
https://github.com/CamJam-EduKit/EduKit3/blob/master/CamJam%20Edukit%203%20-%20GPIO%20Zero/CamJam%20EduKit%203%20-%20Robotics%20Worksheet%202%20(GPIO%20Zero)%20-%20Building%20a%20Robot.pdf
Any help would be thoroughly appreciated, I just want to get programming on this bad boy
Thanks!
Here's the image of the wire next to the port it's supposed to go into. Is it literally as simple as it should be pushing the wire in as hard as possible, or is there a trick to it that I need to be using?
In case it helps at all, this is the workbook guide that shows how to build it:
https://github.com/CamJam-EduKit/EduKit3/blob/master/CamJam%20Edukit%203%20-%20GPIO%20Zero/CamJam%20EduKit%203%20-%20Robotics%20Worksheet%202%20(GPIO%20Zero)%20-%20Building%20a%20Robot.pdf
Any help would be thoroughly appreciated, I just want to get programming on this bad boy
Thanks!