I recently upgraded my computer and installed a new board and chip 2.8mhz. I also bought a serial 80 gig drive. Kept the cd-rom drive that uses the standard ide ribbon cable
When trying to get the drive identified, I found I when the drive is identified the cd-roms ain't, and when I get the cd-rom identified, the drive is like not installed. Played around in the cmos used the various combinations and had no luck.
Also, when trying to install drive, I used a windows 98 boot disk with fdisk and format. I could only achive a 10 gig maximum amount use this method and don't know where the other 70 went.
Anyone gots any ideas
When trying to get the drive identified, I found I when the drive is identified the cd-roms ain't, and when I get the cd-rom identified, the drive is like not installed. Played around in the cmos used the various combinations and had no luck.
Also, when trying to install drive, I used a windows 98 boot disk with fdisk and format. I could only achive a 10 gig maximum amount use this method and don't know where the other 70 went.
Anyone gots any ideas