I currently ran the CPU-Z detection program to look at some technical hardware specs. The SPD tab within the program shows all three sticks of RAM have a max frequency of 133 Mhz, but it says it is running at 100 Mhz.? This quote is from the manual:
my configuration looks like this: slot 1/256Mb pc-133, slot 2/128Mb pc-133, slot 3/128Mb pc-133The AK12 mainboard has three 168-pin DIMM sockets that allow you to install from 16MB up to 1.5GB of system memory with PC 100/133 SDRAM (Synchronous DRAM) and VCM (Virtual Channel Memory) SDRAM. Each DIMM (Dual In-line Memory Module) socket can accommodate 16MB, 32MB, 64MB, 128MB, 256MB and 512MB 3.3V single or double side 64 bit wide data path SDRAM and VCM SDRAM modules.
I have it set in BIOS to run at 133 Mhz. When only one slot has RAM my system runs at 133 Mhz, when I run two sticks (in any combination) it won't even boot up, and when I run with all three (in any combination) it only runs at 100 Mhz. Any ideas why it will only run at 133 Mhz when only one stick of RAM is present?Install memory in any or all of the banks and in any combination. Note: You do not need to set any jumper to configure memory since the BIOS utility can detect the system memory automatically. You can check the total system memory value in the BIOS Standard CMOS Setup menu.You can easily upgrade the system memory by inserting additional SDRAM and VCM SDRAM modules in available DIMM banks. The total system memory is calculated by simply adding up the memory in all DIMM banks. After upgrade, the new system memory value will automatically be computed and displayed by the BIOS Standard CMOS Setup menu.