Everything was working fine with PC133 memory (256 MB), but when I installed some K-Byte 512 MB DDR 2700/2100 184 pin DIMM (single chip), now I don't get the POST beep at all. Well, the first time I installed the new memory, it worked fine. By the way, I did remove the old memory. hehe
But the second time I tried to boot, no POST beep. So if I go back to the old memory everything is fine again. Then I reinstall the DDR and it might boot one time, or it might not. Regardless, it only boots one time maximum and then it won't boot anymore until I reinstall the old memory.
I tried to reset everything in BIOS to defaults, but it did not help. I turned off the "quick boot" thinking that it might help if it tested the memory. No change.
Is there a setting in there somewhere (BIOS maybe?) that I can try that will make my system work with this memory?
Thanks in advance.
But the second time I tried to boot, no POST beep. So if I go back to the old memory everything is fine again. Then I reinstall the DDR and it might boot one time, or it might not. Regardless, it only boots one time maximum and then it won't boot anymore until I reinstall the old memory.
I tried to reset everything in BIOS to defaults, but it did not help. I turned off the "quick boot" thinking that it might help if it tested the memory. No change.
Is there a setting in there somewhere (BIOS maybe?) that I can try that will make my system work with this memory?
Thanks in advance.