Hi all,
I was hoping that someone would have some insight into the following: I recently installed XP and upon startup, my monitor goes into standby mode. This happens whether or not the monitor is on at startup or if I turn it on after startup.
But: If I disconnect the cable from my cp before startup, and then plug it back in after about 30 seconds (approx startup time) the monitor works fine.
Does anyone have a cure for this inconvenience? Is it hardware or software related?
Thanks!
I was hoping that someone would have some insight into the following: I recently installed XP and upon startup, my monitor goes into standby mode. This happens whether or not the monitor is on at startup or if I turn it on after startup.
But: If I disconnect the cable from my cp before startup, and then plug it back in after about 30 seconds (approx startup time) the monitor works fine.
Does anyone have a cure for this inconvenience? Is it hardware or software related?
Thanks!