macdude425
Member (again)
- Messages
- 4,202
Every time I start up my Packard Bell (it's an old P1), it comes up with the message "Invalid System Configuration Data - run configuration utility"
Then, before it starts LILO, it says
"Press <F1> to resume, <F2> to setup"
and hitting F2 takes me to BIOS. I've tried playing with BIOS, and even manually flashing it, but I can't seem to figure it out. Any ideas?
Thanks in advance.
Then, before it starts LILO, it says
"Press <F1> to resume, <F2> to setup"
and hitting F2 takes me to BIOS. I've tried playing with BIOS, and even manually flashing it, but I can't seem to figure it out. Any ideas?
Thanks in advance.