I am working on my older computer and I was wondering if anyone could tell me how to properly set the dram settings. I have an old Soyo Dragon KT600 Plus v. 1.0
The ram I have is a Geil 2 X 256mb, DDR400 2-6-3-3
Mobo Settings
DRAM Clock: 200mhz
DRAM Timing: Manual
DRAM CAS Latency: ??
Bank Interleave: ??
Precharge to Active: ??
TRAS Non-DDR400/DDR400: ??
Active to CMD TRCD: ??
DRAM Burst Length: ??
DRAM Command Rate: ??
Write Recovery Time: ??
TWTR for DDR400 Only: ??
DRAM Access Time: ??
I would sure love to get this thing to run stable for a change. Can anyone help me with this? Thank You All Very Much!
The ram I have is a Geil 2 X 256mb, DDR400 2-6-3-3
Mobo Settings
DRAM Clock: 200mhz
DRAM Timing: Manual
DRAM CAS Latency: ??
Bank Interleave: ??
Precharge to Active: ??
TRAS Non-DDR400/DDR400: ??
Active to CMD TRCD: ??
DRAM Burst Length: ??
DRAM Command Rate: ??
Write Recovery Time: ??
TWTR for DDR400 Only: ??
DRAM Access Time: ??
I would sure love to get this thing to run stable for a change. Can anyone help me with this? Thank You All Very Much!
