Hi, I'm new to these forums, but I'm in need of advise on what to do...
I currently am running on a Dell XPS 400 XPSP2.
Specs: Processor: dual-core Pentium D 940 processor running at 3.2GHz RAM installed: 1 GB DDR II SDRAM; Hard drive: 160 GB Standard
I just purchased a PC2-5400 1GB Single channel. The problem was after I installed the RAM along with my stock sticks I could run my PC for about 15-30 minutes no problem. Everything goes smooth and then all of a sudden I will get a BSOD error. I've tried switching slots, but with my luck found no avail in fixing the problem. One thing I did notice is that when I remove the 5400 stick it is a bit hot. Could these BSOD issues be because of my PSU not being high enough? (375w) Or is it just because my motherboard dosn't support this stick?
I currently am running on a Dell XPS 400 XPSP2.
Specs: Processor: dual-core Pentium D 940 processor running at 3.2GHz RAM installed: 1 GB DDR II SDRAM; Hard drive: 160 GB Standard
I just purchased a PC2-5400 1GB Single channel. The problem was after I installed the RAM along with my stock sticks I could run my PC for about 15-30 minutes no problem. Everything goes smooth and then all of a sudden I will get a BSOD error. I've tried switching slots, but with my luck found no avail in fixing the problem. One thing I did notice is that when I remove the 5400 stick it is a bit hot. Could these BSOD issues be because of my PSU not being high enough? (375w) Or is it just because my motherboard dosn't support this stick?