Out of range

Status
Not open for further replies.

mpeng

Beta member
Messages
2
My monitor recently shown "out of range" and went to standby mode while I am using the pc midway..

When I restart my pc, it said no signal detected. I have attempted to change the graphic card but it still said "signal not detected" I can't even access to BIOS or safe mode to make any changes.

Please advice urgently

:mad:
 
try another monitor if you have one... or open up the case and pull the battery on the mobo for about 5 minutes. that will reset the CMOS back to defualt. it sounds as if the monitor can't handle the resolution it was set at.
 
Hi,

Thanks for the advice.

I have tried using a different monitor and even replace a new graphic card. These doesn't help.

I am just wondering, does my tuner software affect this? Please advice as I desperately required my pc to complete some assignment. Thanks all.
 
Try plugging the computer into a different wall outlet. look into borrowing a power suppl to eliminate that as well.
 
Status
Not open for further replies.
Back
Top Bottom