Need help with Cooler Master 690 case

[eyeCpc]

Don't break anything ok!

 

[jester070993]

Haha I'll try not to.

 

[eyeCpc]

Well those locking inplace tabs are usually in there tight with it being too easy to end up snapping one off. That's why you need to go easy to avoid any ut ohs!

 

[jester070993]

Yeah there really week, I'm afraid I might break one. So you saying all I do is push each tab up?

 

[eyeCpc]

You have to get in there and a get a good look to see what the end of the tab looks like. On some cases the end will have an offset to lock it inplace where you would need to push on it sideways a little and lift up from there.

Sometimes those are beveled a little with tempered angles on all four sides where it is press fitted down inplace during the initial assembly. After a few times you may find that it will tend to loosen up a bit as well.

 

[jester070993]

Ok, I'll keep trying.