Monitor has no signal

Status
Not open for further replies.

CassiusBlack

Solid State Member
Messages
11
Well i thought i had built my pc correctly. I pressed the on switch and it seemed to be working, the fans were going and i could see little lights on the MOBO, cards etc. But my monitor gives me the "no signal or cable unplugged" message. I'm using the monitor from my old pc. Am i missing something? Anyone got any ideas?
 
if it was working correctly, it should give you one beep to say all's okay.
but it's not, so that means you need to go back and find out what you've done wrong. maybe try reseating things, like RAM.
 
hmmm thinking about it i don't think i attached the audio part that was attached to the cables that connect to the on/reset switches...would this make the beep?
 
when i said speaker i wasa referring to the beeper i think that was set to off on the MOBO...

I can't think what the problem is...
 
sorry PSU?

(EDIT: power supply, my bad)

So your saying take out the cd drives and hdd?

What about the various cables?
 
Status
Not open for further replies.
Back
Top Bottom