risingvendetta
Solid State Member
- Messages
- 17
- Location
- USA
Hi!
I have an AFT card reader that has those thin plastic things with 5 wires in them. My MOBO didn't have enought usb pins so I was using a PC|I usb card that had them.
Problem is the pci card seem to not work anymore. So, I bought this converter. It converts the usb pins to a plain ol usb. I can just get a reg. usb card and make it go out the back.
The thing is I know i have to reset the wire and not sure how. The converter list each pin as follows:
3.3v
rst
txd
rxd
gnd
5v
And the wires are these five:
red
green
white
black
and another black but thicker.
How should I resent the wires?
thanks!
I have an AFT card reader that has those thin plastic things with 5 wires in them. My MOBO didn't have enought usb pins so I was using a PC|I usb card that had them.
Problem is the pci card seem to not work anymore. So, I bought this converter. It converts the usb pins to a plain ol usb. I can just get a reg. usb card and make it go out the back.
The thing is I know i have to reset the wire and not sure how. The converter list each pin as follows:
3.3v
rst
txd
rxd
gnd
5v
And the wires are these five:
red
green
white
black
and another black but thicker.
How should I resent the wires?
thanks!