Thnx for your reply Jolance, oh come on, aint a novice here, i know enough from northbrodge to southbridge so no doubt on motherboard. There are things that i've learned over the past few days. I used to overclock my P3 @ 933 using the multiplyer i.e. x7 to x7.8 and further x8. But these days we can overclock the FSB with the help of ram. So upon researching, i found the maximum fasb that the board can support is 200, and when trying to set the multiplyer by selecting manual, im unable to access the options as it must been locked by the manufacturer.
The problem is im unable to pump out anything out of this computer, with a frame rate of 5 its always difficult to run half life 2.
I installed 1. PC 3200 @ 400MHz 256 and 2. PC 2700 @ 333 MHz 256 Rams. I changed this by using a 512 MB PC 3200 RAM, the latency were like 4.7-6-6-7 but it didnt gave much and i still was unable to do anything with the fsb.
So the bottom line is if im unable to change the fsb and multiplyer from bios, does that mean i wont be able to overclock? I tried using RMClock but it wasnt helpful. Finally, in order to pump out halflife at good frame rate do i had had to go for a nvidia geforce? Or a sharp overclocking can help this S3G go high?