After build computer turns on all looks fine but no video....

Status
Not open for further replies.
ok look on the bottom of the lanparty, on the left side. do you see any red LED lights? and you should turn the speaker on, on the lanparty they come defalt off. check your ATX power and the 4 pin above that. also make sure your vid card is seated all the way in and it has power connected through the back.
 
harley3344 said:
ok i could only a 3 pen jump

ok....um? what does that mean. your not getting any beeps, you checkd your power connections? take one stick of ram out and try booting, if it doesnt boot try the other stick.
 
ok i thought that you were talking about the jumps but ignore that... I have tryed one stick in each slot than both in a series of slots still nothing.....
 
Status
Not open for further replies.
Back
Top Bottom