Trancematic
Baseband Member
- Messages
- 21
Need some troubleshooting help with setting up Raid 0.
Asus M2n-SLI Deluxe board, set up the 2 hdds in striping mode. But lost in regards to "JMicron SATAII Controller" currently set to IDE with Disable/Ide/Raid/AHCI options available. Do I need to mess with that? or just leave it in IDE mode, Board has a sata slot for this JMicron SATAII controller. Currently have HDDs in slot 1/2.
Setup the Array with Striping 128k block
When I hit f10 to show raid utiliy, has the following
Boot-Yes
Status-Healthy
Vendor-Nvidia
Array-Stripe 465.77G
Shows both 1st HDD channel 0/index 0 2nd HDD on 1channel/1index. Whats bugging me is the Jmicron boot screen comes up shows no HDD found. so help me out if you can thanks.
If I disable the JMicron sataII controller, works fine bc no screen pops up.
Rem
Asus M2n-SLI Deluxe board, set up the 2 hdds in striping mode. But lost in regards to "JMicron SATAII Controller" currently set to IDE with Disable/Ide/Raid/AHCI options available. Do I need to mess with that? or just leave it in IDE mode, Board has a sata slot for this JMicron SATAII controller. Currently have HDDs in slot 1/2.
Setup the Array with Striping 128k block
When I hit f10 to show raid utiliy, has the following
Boot-Yes
Status-Healthy
Vendor-Nvidia
Array-Stripe 465.77G
Shows both 1st HDD channel 0/index 0 2nd HDD on 1channel/1index. Whats bugging me is the Jmicron boot screen comes up shows no HDD found. so help me out if you can thanks.
If I disable the JMicron sataII controller, works fine bc no screen pops up.
Rem