A newb story: Buying is done...time to build
- Thread starter jfenwick
- Start date
- Status
mgcook
Fully Optimized
- Messages
- 1,723
- Location
- North Carolina
i think we need some pics of the tower 
i think we need some pics of the tower
yup, snap, snap
aspire
The Water Cooling Guru
- Messages
- 5,308
- Location
- United States
this thread is worthless without pictures!
LMAO...i'll get you guys a couple...lol, should be a good laugh at the pre-wiremanagement set up.
That's my one complaint so far with the 900, not much room for wire management. then again, I don't know much about wire management so maybe i'm not looking in the right places!
I'll get some up here asap...gotta work right now....pay this thing off!
That's my one complaint so far with the 900, not much room for wire management. then again, I don't know much about wire management so maybe i'm not looking in the right places!
I'll get some up here asap...gotta work right now....pay this thing off!
phucng_10
Fully Optimized
- Messages
- 2,456
- Location
- San Jose, California
Build it and post the wire management in my thread! :laughing:
mgcook
Fully Optimized
- Messages
- 1,723
- Location
- North Carolina
phucng_10
Fully Optimized
- Messages
- 2,456
- Location
- San Jose, California
So how did he actually make those holes? Use a knife and made a small hole? How?
AMAZING.....i have a headache just thinking about the work that will take...and after all the time I spent putting it together, to take it apart again...but man that looks good. Do I dare...
phucng_10: He made the holes with a dremel and drill I'd think...didn't read the entire thread but that's how I'd do it, both are easy to use and will cut through sheet metal with ease...with the proper bits.
- Status
Similar threads
