Jumper caps - DFI Lanparty SLI-DR

Status
Not open for further replies.
I believe that may be the RAM, try just one stick in slot 3, and then the other.
 
Right i removed one and i got a screen saying

"Lanparty NF4 SLI something"..

Dont know what happens after that because i havn't got a mouse/keyboard in it yet.

So it works with either one... is there some setting i was meant to have the ram too? to use two?
 
Ok the screen "Lanparty NF4" screen it doesnt do anything.. dont know if thats due to the side panel being off
 
Yeah it doesnt allow me to do anything - i am wondering if need to connect the FDD to the connection on the motherboard as i only just connected.

Everything else i think is ok but it just hangs on the "Lanparty NF4" screen
 
This is what it looks like at the minute and brings up the screen and hangs (and doesnt let me press anything):



This is what the mobo loks like:

 
I bet you if you clear cmos you will fix it. You can do it one or two wats taking out the round battery thing towards the bottom (hard) or look into your mobo manual and it should say what you put the jumpers on. That should be your problem.
 
Status
Not open for further replies.
Back
Top Bottom