Got my second 4870, How do I crossfire???

Status
Not open for further replies.

shan1784

In Runtime
Messages
396
Location
Michigan
Might be a dumb question but how do I do it... Is it as simple as installing the second card, connecting the cables to each other and that's it?

Not sure if there are specific drivers I need, or if some other setup in BIOS or CCC... Any help would be appreciated...
 
Nope, just throw the bridge on, plug in the Power Connector into your second, then you'll need to have Catalyst Control Center installed... and enable Crossfire in the settings

Then your done :)
 
Crossfirex is actually enabled by default. Plug in 2nd card, put BOTH bridges on, boot up.

I swear every single time i pull my cards out, i forget to put my bridges back on.
 
Status
Not open for further replies.
Back
Top Bottom