Hey everyone!
As the title of the thread suggests, I have a simple MSI 785GTM-E45 board with two sticks of OCZ 1066 2GB RAM.
When I loaded up the BIOS for the first time (just completed build), I looked at a couple of things and it reads that the RAM is 800.
I had read somewhere that a few settings had to be changed in the BIOS to make it clock at 1066, but, for the life of me, I cannot find that information again.
Does anyone have any step-by-step instructions to assist me in getting the latency to 1066?
As always, I greatly appreciate your help!
Well, I changed the FSB/DRAM Ratio to 1:2.66 and after a reboot, it lists the frequency at 1066.
So, I think I'm all set. Let me know if I should change anything around for better performance!
As the title of the thread suggests, I have a simple MSI 785GTM-E45 board with two sticks of OCZ 1066 2GB RAM.
When I loaded up the BIOS for the first time (just completed build), I looked at a couple of things and it reads that the RAM is 800.
I had read somewhere that a few settings had to be changed in the BIOS to make it clock at 1066, but, for the life of me, I cannot find that information again.
Does anyone have any step-by-step instructions to assist me in getting the latency to 1066?
As always, I greatly appreciate your help!
Well, I changed the FSB/DRAM Ratio to 1:2.66 and after a reboot, it lists the frequency at 1066.
So, I think I'm all set. Let me know if I should change anything around for better performance!
