Catalyst Problems...help!

Status
Not open for further replies.

gurusan

Golden Master
Messages
6,562
Location
Portland, OR
I just got a 3870 in the post to crossfire with my 3850...but the catalyst control center won't start.

I've uninstalled the drivers completely, uninstalled .net framework 1.1, run driversweeper, and reinstalled but the screen turns black during catalyst install, so I waited til the hd light stopped blinking and then shut down the computer using alt-f4.

Upon reboot I get the following message:



Yet, as you see Crossfire is enabled and I tested CoD4 and crossfire is definitely working, it's quite a bit faster than my voltmodded 8800GTS 512mb was. Frame rate is consistently over 100fps 1680x1050 with 4xAA

However, my issues are:

-Unable to access CCC so I can't change 3d settings and such
-Rivatuner only shows 1 adapter :( so I can only overclock the 3870 and not my 3850 which is pencil modded and good for 960 core.

I've uninstalled and reinstalled the drivers several times now, but get the same problems.
 
ok well I got it working under XP x64 now at least, but now even though both gpu-z and ccc say crossfire is enabled, it doesn't seem to be working!

Only 1 gpu heats up in a 3dmark06 run. How can i fix this?
 
Status
Not open for further replies.
Back
Top Bottom