Raphael Argus
Daemon Poster
- Messages
- 533
Hello Everyone,
Appreciate any troubleshooting advice, I installed a new SATA drive and chose the combine install in the BIOS to run both a SATA as master and have a secondary IDE. I did NOT change the jumpers on the IDE, I left them at cable select. My primary drive is a Maxtor and it came with MaxBlast software which I booted from initially and then installed my OS. Everything went smoothly, except the IDE drive is not being seen.
What types of troubleshooting steps should I take for this? Before I start screwing things up I'll post here, since all the advice I was given here for installing the SATA drive was perfect =)
250GB Maxtor SATA0
75GB Western Digital IDE on cable select
the 75GB drive does have my OC XP Pro on it and it was my previous boot drive. Essentially, I did nothing physically to the drive, just enabled SATA controller in BIOS and chose combine to run both SATA and IDE.
If you need more information, LMK!
Appreciate any troubleshooting advice, I installed a new SATA drive and chose the combine install in the BIOS to run both a SATA as master and have a secondary IDE. I did NOT change the jumpers on the IDE, I left them at cable select. My primary drive is a Maxtor and it came with MaxBlast software which I booted from initially and then installed my OS. Everything went smoothly, except the IDE drive is not being seen.
What types of troubleshooting steps should I take for this? Before I start screwing things up I'll post here, since all the advice I was given here for installing the SATA drive was perfect =)
250GB Maxtor SATA0
75GB Western Digital IDE on cable select
the 75GB drive does have my OC XP Pro on it and it was my previous boot drive. Essentially, I did nothing physically to the drive, just enabled SATA controller in BIOS and chose combine to run both SATA and IDE.
If you need more information, LMK!