Memmory problem

Status
Not open for further replies.

Micro Rotors

Solid State Member
Messages
10
Hello guys,

I just put together a new machine and it has been running fine for a week now. When it boots up as the text comes up on the screen it used to say "Duel Channel DDR" now it says "Single Channel DDR",

The machine runs fine and it registers all the memory (2 - 512's)

What happened?

Thanks
Bill
 
Take one of your sticks out and boot it up... see if it reverts back to Dual Channel...

Have you been tinkering in the bios at all ?
Can you download and install CPU-z, then run the cpu-z and post screen shots.
 
Did you try taking one stick out and booting it up with 512 to see if the DDR reverts ?

Can you post a screen shot of your Memory Tab and SPD tab for me ?
 
well its registering in CPU Z as DDR so thats good atleast.


You could be having a slot issue... what i mean by this, is you may want to test alternate slots on the board... I know that some boards only run the RAM correctly if there are in the spots specified in the MOBO manual.

Also... have you checked out the booting with one stick yet ?
 
jeezzzz it wont let me add a file I u/l again and the first one didnt take. sorry for the last one, it looks bad

Bill
 
Status
Not open for further replies.
Back
Top Bottom