Hi, everyone!
I have a problem with WinRoute 6. I have two comupters connected to my main computer which acts as a gateway for them. One connection is through the net cable and one is wifi. WinRoute shares the internet connection with them with no problem. There is one thing though which doesn't work, the port mapping.
Here is how I set it up:
Source -> Internet ADSL (my net interface)
Destination -> Firewall (192.168.0.1 - gateway ip doesn't work either)
Service -> TCP 20000-40000 (doesn't matter, simple HTTP doesn't work as well)
Action -> Permit
Translation -> MAP 192.168.0.20 (my laptop on the wifi network, can be pinged so everything should be fine)
I check all that in that way that I start NetCat listening on port ex. 25000 (nc -lp 25000) (on the computer behind NAT) and then try to connect to it also with netcat using my Internet IP ex. nc 80.123.588.33 25000. NetCat doesn't connect and just bails.
Has any of you had problems earlier with mapping ports with WinRoute 6 ?
Regards,
Black Dot
I have a problem with WinRoute 6. I have two comupters connected to my main computer which acts as a gateway for them. One connection is through the net cable and one is wifi. WinRoute shares the internet connection with them with no problem. There is one thing though which doesn't work, the port mapping.
Here is how I set it up:
Source -> Internet ADSL (my net interface)
Destination -> Firewall (192.168.0.1 - gateway ip doesn't work either)
Service -> TCP 20000-40000 (doesn't matter, simple HTTP doesn't work as well)
Action -> Permit
Translation -> MAP 192.168.0.20 (my laptop on the wifi network, can be pinged so everything should be fine)
I check all that in that way that I start NetCat listening on port ex. 25000 (nc -lp 25000) (on the computer behind NAT) and then try to connect to it also with netcat using my Internet IP ex. nc 80.123.588.33 25000. NetCat doesn't connect and just bails.
Has any of you had problems earlier with mapping ports with WinRoute 6 ?
Regards,
Black Dot
