I IBMan Daemon Poster Messages 1,084 Nov 10, 2004 #1 so i made a crossover cable using a standard network cable....after i make it how do i setup the software or w/e in the 2 computers to use it?
so i made a crossover cable using a standard network cable....after i make it how do i setup the software or w/e in the 2 computers to use it?
OP OP I IBMan Daemon Poster Messages 1,084 Nov 10, 2004 #2 o sorry both running windows 2000 or windows XP
TheMajor PowerQuest / Opera Messages 10,176 Location Netherlands Nov 10, 2004 #3 Connect the computers with the cable and run the network connection wizard. (somewhere in your startmenu)
Connect the computers with the cable and run the network connection wizard. (somewhere in your startmenu)
S s0me0ne In Runtime Messages 303 Nov 11, 2004 #5 Dont run the wizzard (i hate it hehe) just assign the machines ips manually then make sure you can ping and your good to go theres no special setup with a cross over setup to cross over cables. Hope this helps.
Dont run the wizzard (i hate it hehe) just assign the machines ips manually then make sure you can ping and your good to go theres no special setup with a cross over setup to cross over cables. Hope this helps.