gurusan
Golden Master
- Messages
- 6,562
- Location
- Portland, OR
I'm going to make a sort of holder/case/shroud thing for a 120.2 radiator so that it will mount above my Antec 900 240mm fan.
I would like to use black plexiglass, I've found some online for a good price.
My questions are:
-How do I cut it? The sheet is 3mm thick and I was thinking of just using a stanley knife to make some cuts, then just snap it?
-How do I glue the parts together? Which glue should I use? I was thinking of just roughening up the edges a bit with some sandpaper and then using some sort of silicone adhesive? Which would you recommend?
Thanks.
I would like to use black plexiglass, I've found some online for a good price.
My questions are:
-How do I cut it? The sheet is 3mm thick and I was thinking of just using a stanley knife to make some cuts, then just snap it?
-How do I glue the parts together? Which glue should I use? I was thinking of just roughening up the edges a bit with some sandpaper and then using some sort of silicone adhesive? Which would you recommend?
Thanks.