USB Jumpers on abit case

Status
Not open for further replies.

forlorn_ronin

In Runtime
Messages
167
I recently bought a raidmax samurai case and abit av8 guru mobo. The front of case has two usb ports and audio headphone jacks. Unfortunately, when putting this together the jumpers for the additional usb ports on the mobo are configured as follows:

FPUSB1

2 4 6 8 10
1 3 5 7

FPUSB2

2 4 6 8 10
1 3 5 7


THE PIN ASSIGNEMENTS ON JUMPERS ARE AS FOLLOWS:

PIN 1 = VCC
PIN 2 = VCC
PIN 3 = - DATA 0
PIN 4 = - DATA 1
PIN 5 = + DATA 0
PIN 6 = + DATA 1
PIN 7 = GROUND
PIN 8 = GROUND
PIN 10 = NC

My problem is that the cables from the front side usb ports only have four holes with an additional one for the ground. I have set the first usb on jumper FPUSB 1 covering pins 2 4 6 8 10 leaving the bottom pins open. I have set the second usb port on jumper FPUSB 2 covering pins 2 4 6 8 10 leaving the bottom pins open.
1 3 5 7 uncovered. Will this work? If not how do I remedy this?

Regarding the jacks for the headphones and audio/mic. They have solid input pins like how a speaker system has an input jack. Where in the heck do these go? There is no where to put them!

Thanks for all the help

~ronin~
 
Status
Not open for further replies.
Back
Top Bottom