Originally Posted by nagasama
make sure the ram has the proper voltage and timings.
begin to increase the external cpu clock in increments of 10-15, and use prime95 or (i prefer) orthos to test for stability, at the BARE MINIMUM a couple of hours. this is just the preliminary stability test, when you reach a good clock, you can test it for 8 hours or so.
try these steps and post back if you have questions.
How can i check before hand if my timings are corrent and voltage too?
and while increasing cpu clock by 10-15...how long should i scan for each increase? And when should I scan for 8 hours?
Since i only want to get to 2.4 ghz max should i scan for 8 hours after that?
and i dont wanna raise my voltage, a lot of people say I dont need to...